Concrete Calculator — Cubic Yards, Bags & Cost

Enter your slab, footing or column dimensions and get cubic yards, bag counts for 40, 60 and 80 lb mixes, and an estimated cost — with a waste allowance built in.

Quick answer

A 10×10 ft slab, 4 in thick needs 1.23 cu yd — about 56 bags of 80 lb mix (before waste).

Concrete calculator

Results update as you type. Your numbers are saved in the page link, so you can bookmark or share them.

Shape
Units
Slab dimensions
ft
ft
in
Waste allowance
10%
Prices (optional)
1.36
cubic yards incl. waste
62
80 lb bags (rounded up)
Exact volume (no waste)1.23 cu yd · 33.3 cu ft · 0.94 m³
60 lb bags82
40 lb bags123
Approx. weight incl. waste2.75 tons

Includes a 10% waste allowance — adjust with the slider. Bag counts always round up to whole bags. Weight assumes ~150 lb per cubic foot of cured concrete.

How the concrete calculator works

Concrete is ordered by volume, and in the United States that volume is measured in cubic yards (one cubic yard = 27 cubic feet). The calculator turns your three measurements — length, width and thickness — into a volume, adds a waste allowance, then converts that volume into the numbers you actually shop with: how many bags of 40, 60 or 80 lb mix to buy, how much a ready-mix truck should deliver, and roughly what the material will cost.

The math, step by step

cubic feet = length (ft) × width (ft) × thickness (in) ÷ 12
cubic yards = cubic feet ÷ 27
order volume = cubic yards × (1 + waste %)
  • 80 lb bag: each yields 0.60 cu ft, so bags = volume in cu ft ÷ 0.60 (45 bags per cubic yard).
  • 60 lb bag: each yields 0.45 cu ft (60 bags per cubic yard).
  • 40 lb bag: each yields 0.30 cu ft (90 bags per cubic yard).
  • Weight: cured concrete runs about 150 lb per cubic foot, so a cubic yard weighs roughly 4,050 lb (about 2 tons).
  • Round column: volume = π × (diameter in ft ÷ 2)² × height in ft.
10 ft 10 ft 4 in thick (side view) slab, top view
A 10 × 10 ft slab, 4 in thick: 33.3 cu ft = 1.23 cu yd before any waste allowance.

Thickness is where most DIY estimates go wrong. A slab "about four inches" that actually averages five inches over a 10 × 20 ft area holds more than 8 cubic feet of extra concrete — nearly a third of a yard. Measure the average thickness of your formwork at a few points, and let the waste slider absorb small variations. If your subgrade is soft or uneven, bump the allowance to 15%.

Worked example: a 10 × 10 ft patio slab

Here is the full calculation for the most searched project size in America, a 10 by 10 foot patio at 4 inches thick:

  1. Volume. 10 ft × 10 ft × (4 in ÷ 12) = 33.33 cubic feet. In yards: 33.33 ÷ 27 = 1.23 cubic yards.
  2. Waste allowance. 1.23 × 1.10 = 1.36 cubic yards to order.
  3. Bagged mix. 33.33 × 1.10 = 36.67 cu ft. At 0.60 cu ft per 80 lb bag: 36.67 ÷ 0.60 = 61.1 → buy 62 bags of 80 lb mix (or 82 of the 60 lb bags, or 123 of the 40 lb bags).
  4. Weight. 36.67 cu ft × 150 lb = about 5,500 lb of cured concrete — roughly 2.75 tons. That is why bags come on pallets and a wheelbarrow-only pour is a long day.
  5. Cost. At a typical $6.00 per 80 lb bag: 62 × $6.00 ≈ $372 bagged. Ready-mix at $150–$170 per yard with a short-load fee would have run roughly $220–$330 delivered — cheaper, but you pay for a minimum load and need wheelbarrow or pump access on pour day.

The quick-answer box at the top of this page updates to your own dimensions as you type, so once your tape measure has numbers, the math above happens automatically.

Quick reference tables

Speed sheetCommon concrete projects

Volume and 80 lb bag count for frequently poured sizes (10% waste included)
ProjectSizeExact volumeOrder volume80 lb bags
Patio slab10 × 10 ft, 4 in1.23 cu yd1.36 cu yd62
Shed pad12 × 12 ft, 4 in1.78 cu yd1.95 cu yd88
One-car driveway10 × 20 ft, 5 in3.09 cu yd3.40 cu yd153
Two-car driveway20 × 20 ft, 5 in6.17 cu yd6.79 cu yd306
Continuous footing50 ft × 16 in × 8 in1.65 cu yd1.81 cu yd82
Round column12 in dia × 4 ft0.12 cu yd0.13 cu yd6

Bag counts assume 0.60 cu ft per 80 lb bag and round up to whole bags.

Bag yields by mix size (manufacturer data)
BagYieldCoverage at 4 in thickBags per cubic yard
40 lb0.30 cu ft1.8 sq ft90
60 lb0.45 cu ft2.7 sq ft60
80 lb0.60 cu ft3.6 sq ft45
Recommended strength (PSI) by project — always follow local code or your engineer
ProjectTypical PSINotes
Footings and walls2,500–3,000Follow structural drawings; rebar changes no volume.
Patios and walkways3,500Air-entrained mix in freeze-thaw climates.
Driveways4,000–4,5004–6 in thick over a compacted gravel base.
Countertops / overlaysSpecialtyUse dedicated mixes; yields differ from bag math above.

Bagged concrete is sold as "just add water" mixes: the cement, sand and gravel are proportioned for you, so the only number you control is water. If you are mixing raw materials instead, a common 3,000 PSI field ratio is 1 part cement, 2 parts sand and 3 parts gravel by volume — but for anything structural, buy the pre-blended bags or order transit-mix and let the batch plant hit the strength.

What concrete costs

Concrete pricing has two very different paths, and the breakeven sits near one to one-and-a-half cubic yards:

  • Bagged mix: 80 lb bags typically run $5–$7 each at big-box stores. That works out to roughly $270–$330 per cubic yard — convenient for small pads and post holes, expensive past a yard, and you haul every pound yourself.
  • Ready-mix (transit truck): typically $140–$170 per cubic yard delivered, plus a short-load fee (often $50–$150) on orders under about 4–5 yards, and possible charges for weekend or after-hours pours.

What moves the price: regional concrete costs, the strength (PSI) you order, additives like fiber mesh or air entrainment, delivery distance, and whether the truck has to wait on site. Prices here were checked in November 2026 and will drift — they are planning numbers, not quotes. For anything above two yards, get two or three local quotes; for anything structural, your permit office or engineer specifies the mix.

How the cost line is billed: ready-mix plants sell by the whole cubic yard and will not dispatch a third of one, so the estimate rounds your order up before multiplying — a 1.36-yard slab is billed as 2 yards. Pours under two yards often carry a short-load fee as well, which is why two bags-and-a-wheelbarrow pads can beat one small truck order. When you call for prices, ask for the delivered per-yard rate, the short-load rule and the minimum load, then compare that total against the bagged cost at your retailer for the same pour.

Frequently asked questions

How many bags of concrete do I need for a 10×10 slab?

A 10×10 ft slab at 4 inches thick is 1.23 cubic yards: 56 bags of 80 lb mix, 75 bags of 60 lb, or 112 bags of 40 lb before any waste allowance. With a 10% waste allowance, order 62 of the 80 lb bags (82 of the 60 lb, or 123 of the 40 lb).

How much is a cubic yard of concrete?

One cubic yard is 27 cubic feet and covers 80 sq ft at 4 inches thick (or 54 sq ft at 6 inches). It weighs roughly 4,050 lb — about 2 tons — so anything over a yard is usually delivered, not carried.

How much extra concrete should I add for waste?

Add 10% for a typical DIY slab in good formwork, 5% for clean formed work by an experienced hand, and 15% if the grade is uneven or the subgrade is soft. Running short means a cold joint: a weak seam between two pours that never fully bonds.

How thick should my concrete slab be?

Walkways and patios: 4 inches. Driveways: 4–6 inches over a compacted gravel base. Shed pads: 4 inches. Whatever the target, measure the average depth of your formwork — an inch of sag across a big slab adds real volume.

Should I use bags or order ready-mix concrete?

Up to about 1 cubic yard, bags are easier — no truck access or short-load fees. Between 1 and 2 yards it is a toss-up; beyond 2 yards, ready-mix is usually cheaper per yard, faster, and far less mixing. Ask suppliers about minimum loads and short-load fees first.

How much does a bag of concrete weigh once mixed?

Cured concrete runs about 150 lb per cubic foot. A single 80 lb bag makes 0.60 cu ft — around 90 lb of cured concrete. A full cubic yard (45 of the 80 lb bags) ends up near 4,050 lb.

How long before I can walk on or drive on new concrete?

Foot traffic in 24–48 hours, furniture and planters after about a week, and vehicles after 7 days at minimum. Full design strength arrives at 28 days. Keep it moist in hot weather and never let it freeze in the first week.

Do I need rebar or wire mesh in my slab?

Reinforcement does not change the volume this calculator produces, but it does change strength. Driveways and patios in freeze-thaw areas typically use rebar or fiber mesh; check your local code or structural drawing before you pour.

Assumptions and limitations

  • Bag yields (0.30 / 0.45 / 0.60 cu ft) come from manufacturer datasheets for standard concrete mixes; specialty products yield differently.
  • Weight is estimated at 150 lb per cubic foot of cured concrete; the actual figure varies with aggregate and air content (roughly 145–155 lb/cu ft).
  • The estimate covers concrete volume only — not rebar or mesh, formwork, gravel base, excavation, subgrade compaction, finishing tools, labor, or disposal. Setting fence posts is a different job — the fence calculator sizes post holes and their concrete separately.
  • Costs are national planning ranges checked November 2026; your local prices will differ. Always confirm with suppliers before ordering.
  • Bag counts round up to whole bags. Unopened bags are usually returnable — keep receipts.
  • This calculator is for planning. Structural work (footings, load-bearing slabs) needs drawings, permits and inspections from your local building department.

Sources

  • Quikrete® product data sheets — yields for 40, 60 and 80 lb concrete mixes (quikrete.com).
  • Sakrete product specifications — bag yields and coverage (sakrete.com).
  • Portland Cement Association — concrete basics, curing times and PSI guidance (cement.org).
  • Big-box retailer listings — bagged concrete pricing, checked November 2026.

Last reviewed: November 20, 2026, by the YardMath Editorial Team. Formulas re-checked against manufacturer datasheets; national price ranges refreshed quarterly.